| Install new bolt handle (handle not included) starts at |
$175.00 |
| Inlet new bolt handle to stock and receiver |
$45.00 |
| Checker bolt handle (per panel) |
$100.00 |
| Drill and tap rifle receivers for scope mounts |
$60.00 |
| Drill and tap for open sights front & rear |
$75.00 |
Drill and tap hard receivers
(Springfield, Enfield, Savage 99, Ruger Mini 14) |
$75.00 |
| Drill and tap for side mounts starts at |
$60.00 |
| Drill and tap for peep sights |
$60.00 |
| Inlet stock for peep sights or side mounts |
$60.00 |
| Jewel bolt |
$100.00 |
| Jewel extractor |
$50.00 |
| Jewel follower |
$50.00 |
| Zero in rifle at range, ammo not included |
$90.00 |
| Glass bed finished rifle starts at |
$100.00 |
| Install aluminum pillars and glass bed starts at |
$140.00 |
| Inlet & glass bed semi-inlet stock |
$60.00hr |
| Dovetail .22 rifle for tip-off rings |
$75.00 |
| Dovetail for open sights (per cut) |
$40.00 |
| Dovetail front and rear same set up |
$75.00 |
| Trigger work on request starts at |
$60.00 |
| Alter Remington model 760 From 35 Rem. to 358 Win or 35 Whelen |
$175.00 |
| Rechamber most rifles (bolt, extractor & feeding work additional) starts at |
$175.00 |
| Mill model 70 Win. & 700 Rem. for stripper clip |
$150.00 |
| Install swivels, Michaels or similar |
$25.00 |
| Install swivels when drilling & tapping is required |
$30.00 |
| Fit low swing safety (Timney,Wisner or Dayton Traister) |
$60.00 |
| Convert Remington 700 to Sako style extractor (parts additional) |
$125.00 |
| Install three position safety (safety not included) |
$60.00hr |
| |
 |
.gif)
